1 · Company
Who performs the cutting test
2 · Cutting process
Select type — relevant parameters appear below
3 · Material
Material group + certificate (mandatory)
Grade & group are common. Charge and certificate can differ per piece — set below.
4 · Test pieces — thinnest · middle · thickest
Per D.3.2 the thinnest and thickest shall be cut. Enter parameters for each.
5 · Cutting geometry — how the sample is cut
Common shape for all pieces (Figure D.1). Thickness is entered per piece above.
Dimensions in mm
EN 1090-2 Figure D.1 — recommended test-piece shape. Straight cut B (measurement area) ≥ 200 mm; hardness measured in areas A & B; sharp corner and curved bends (R5/R10/R40/R80) checked visually.
Fixed shape per EN 1090-2 Figure D.1: overall 380 × 240 mm · top chain 120 / 80 / 100 / 80 · side chain 80 / 80 / 80 · radii R5 · R10 · R40 · R80. Straight cut B is the measurement area (≥ 200 mm).
6 · Shipping
Samples are sent to the test institute — they issue the final documentation
Company: Relabo UAB
Address: Suderves g. 14M, Avizieniai, LT-14192 Vilniaus r. sav., Lithuania
Phone: +370 611 05514
Email: [email protected]
Manager: Aurimas Jurcius
Address: Suderves g. 14M, Avizieniai, LT-14192 Vilniaus r. sav., Lithuania
Phone: +370 611 05514
Email: [email protected]
Manager: Aurimas Jurcius
Marking of each sample: Charge · Thickness · Cutting-process no.
→ generated automatically per piece below (e.g. CH12345-8mm-P01)
→ generated automatically per piece below (e.g. CH12345-8mm-P01)